The Specialist In Drum Handling Equipment
Model 400AM-60
Hydra-Lift, 60”, with Spark Resistant Parts,
Manual Lift & Tilt
Operator’s Manual for Morse Hydra-Lift Karrier Model 400AM-60
with Serial Number 0414 to ____ (MMYY)
morsedrum.com
Copyright 2019 - Morse Mfg. Co., Inc. Form OM400AM-60 (0414-____)
(Updated 12 Jun, 2019 11:34 AM)
4
WARNING
- Watch Out for Pinch Points
Stay clear of moving parts. Operator should remain behind the push handle during the lift operation.
Floor Lock
The screw-down floor lock is located on the base of the tower (fig
-
ure 3.1). Turning the floor lock clockwise until it locks in the down
position activates the floor lock. When the floor lock is activated
it prevents unwanted free wheeling of the unit. Floor conditions
determine the effectiveness of the floor lock. The operator should
verify its holding action before depending on it to hold.
MORcinch Drum Holder Assembly
The drum holder assembly (or “saddle assembly”) is the compo-
nent on the Hydra-Lift Karrier that is intended to hold the drum.
The MORcinch drum holder assembly is designed to secure a
standard ribbed 55-gallon steel drum around it’s middle using a
cinch chain and ratchet tightening system. The MORcinch drum
holder accepts accessories for handling a plastic drum, a fiber
drum, or smaller diameter drums (see Options on pg. 3).
Figure 3.1
Assembly Instructions
Unpack and identify the following parts:
1 Each
Tower with hydraulic pump and cylinder, etc.
2 Each
Legs with wheels
1 Each
Overhead assembly with drum holder, etc.
1 Each
Hardware Package containing:
Part #
Description
Quantity
1166-P
WASHER, 3/8 USS 1” OD, ZINC
4
1521-P HHCS, 3/8-16 X 3 GR5
4
1169-P NUT, 3/8-16 REV HEX LOCK
4
17-P WASHER, 5/8 SAE FL 1-5/16 OD
4
6061-P
PIN, CLEVIS, 400, GREASE FIT
2
NOTE: The clevis pins and mating surfaces at their joints should be coated with grease during assembly.
