25
4.3.2 Trunk-port setting
In the navigation bar to select
“VLAN config>trunk-port setting”
,can set port to Trunk
port,the following picture
:
【
parameter description
】
parameter
description
Native VLAN
Only set one
Allowing vlan
Can set up multiple
【
instructions
】
Native VLAN:
as a Trunk, the mouth will belong to a Native VLAN. The so-called Native
VLAN, is refers to UNTAG send or receive a message on the interface, is considered
belongs to the VLAN. Obviously, the interface of the default VLAN ID (PVID) in the IEEE
802.1 Q VLAN ID is the Native VLAN. At the same time, send belong to Native VLAN
frame on the Trunk, must adopt UNTAG way.
Allowed VLAN list:
a Trunk can transport the equipment support by default all the VLAN
traffic (1-4094). But, also can by setting the permission VLAN Trunk at the mouth of the list
to limit the flow of some VLAN can't through the Trunk.
【
Configuration example
】
Such as
:
PVID=VLAN2
PC1
:
192.168.2.122,port 8, access VLAN2
PC2
:
192.168.2.123,port 9, Trunk allowed VLAN 1-2