Morphy Richards Supreme Precision 10 in 1 Multicooker, Instructions Manual

Page: 28 / 32

28
•
E1
•
The motor is overloaded.
•
Reduce the amount of food in
the Jug (4) .
•
Remove any food residue from
the Paddle (11) , or Blades
(12) , (13) .
Error Code Cause Solution
•
The device doesn't work.
•
Your Multicooker is not
connected to the mains.
•
The Mains Lead (19) is not
properly connected to the Cable
Socket
(7) on the Main Unit (5) .
•
The On/Off Switch (9) is set to
off or your Multicooker is in
standby.
•
Plug the Mains Lead (19) into
the socket on the wall.
•
Switch the On/Off Switch (9) to
off, and insert the Mains Lead
into the Cable Socket.
•
Switch the On/Off Switch on, or
press the Standby Button
(22) .
Problem Issue Solution
•
E3
•
The Jug (4) is not correctly
inserted into the Main Unit (5) .
•
The Jug was removed during
use.
•
Insert or replace the Jug into
the Main Unit.
•
E5
•
The Motor burn out safety
switch has switched on.
•
Let your Multicooker cool down
for at least 30 minutes.
If the problem persists after
cooling down, contact Morphy
Richards.
Error Codes
Troubleshooting
•
The buttons (21)-(30) do not
react immediately.
•
The buttons on the Control
Panel
(8) require the right
contact time.
•
Touch or press the buttons for a
longer period.
•
Water is leaking from the Lid (2)
•
The Lid Gasket (16) is not
attached correctly.
•
The Lid Gasket in the Lid is
damaged
•
Check the Lid Gasket on the
underneath of the Lid is in place
and correctly attached.
•
Contact Morphy Richards.
• The Lid (2) is open but the Lid
Lock Icon (33) on the Control
Panel (8) shows the closed
padlock.
• There is some food in the
sensor at the top of the Jug
Handle
(3) or on the Main Unit
(5) .
• Remove any food residue left
on/in your Multicooker, if the
problem persists, do not use.
Contact Morphy Richards.
•
The programme has stopped
before the end.
•
Your Multicooker has lost power
temporarily.
•
Switch the On/Off Switch (9) to
off, and check the Mains Lead.
Continue the recipe using the
manual settings.
•
The Mixing or Pulse functions
are not working.
•
The Lid is not correctly attached
to the Jug.
• These functions are not
available during this part of the
process.
•
Correctly attach the Lid to the
Jug.
• Do not try to use.
562000 Rev2.qxp_Layout 1 19/01/2015 09:25 Page 28