7
Radio operation
•
To obtain maximum FM reception fully extend the wire FM aerial (which is located
at the rear of the unit) and alter the direction of the wire for best results.
•
The aerial for the MW waveband is located inside the unit. To obtain maximum
MW reception rotate the clock radio.
1
Press the
POWER / SLEEP
button.
2
Adjust the
VOLUME
control to a suitable level.
3
Press the
BAND
button to either MW or FM as desired.
4
Press
UP or DOWN
buttons to select the desired station. Hold
UP or DOWN
for about 1 second. The radio automatically tunes to the next higher or lower
station with a strong signal.
5
To switch off the radio, press the
POWER / SLEEP
button.
Notes
If no strong signal is found, press the
UP or DOWN
buttons
to stop tuning.
Using the memory
You can store up to 20 stations in memory (MW x 10, FM x 10). Follow these steps
to store a station into memory.
1
Tune to the band and station you want to store.
2
Hold
MEM
until MEMO flashes.
3
Within 15 seconds, press
buttons 1-5
on the display for the desired memory
location. You can also repeatedly press
UP or DOWN
buttons until the number
(0-9 in each band) for the desired memory location appears.
4
Press
MEM
again to store the station in the memory location.
Note
: If you do not store the station within 15 seconds, MEMO disappears. Repeat
steps 2-4.
•
To tune to a stored station, repeatedly press and release
MEM
until the numbers
for the desired memory location and the station appear. For presets 1-5, you can
press number key 1-5 to recall the stored station.
