Morooka MST-800VD, Operation & Maintenance Manual

Page: 56 / 134

2-22
2.11 SEAT BELT
• Before fastening seat belt, always check that there is no abnormality in the belt mount or seat belt clamps.
If there is any wear or damage, always replace the seat belt.
• Always adjust the seat belt and fasten it before starting operations.
The seat belt is installed
to prevent the danger of the operator falling from the operator’s seat if the machine tips
at an angle when traveling.
• Do not use the left or right seat belts when they are twisted.
NOTICE
When the seat belt has been used for a long period, and the belt is
damaged or starting to become fluffy, or if the clamps are broken or
distorted, replace with a new seat belt.
Always replace the seat belt once every three years even if there is no
visible sign of abnormality.
[1] FITTING AND RELEASING SEAT BELT
1. Sit in the operator's seat, push your back against the back of the seat, and
adjust the operator's seat to a position where it is possible to operate the
travel lever easily. For details, see 2.10 OPERATOR'S SEAT in the
operation section
2. Hold seat belt buckle (1) and tongue (2) in your left and right hands, and
insert tongue (2) into buckle (1).
3. Pull the seat belt to check that the tongue and buckle are locked securely.
4. When removing the seat belt, press the center of buckle (1) and pull out
tongue (2).
[2] ADJUSTING SEAT BELT LENGTH
Adjust the seat belt so that it fits your body without twisting and so that the
buckle is in the center at the front.
• TO MAKE SHORTER
Holder stopper (3) of the seat belt on the tongue side, then pull the seat belt
at a point between tongue (2) and stopper (3) towards tongue (2).
This will move stopper (3) towards the seat mount and will shorten the seat
belt.
• TO MAKE LONGER
Holder stopper (3) of the seat belt on the tongue side, then pull the seat belt
at a point between tongue (2) and stopper (3) towards the seat belt mount.
This will move stopper (3) towards the tongue (2) and will lengthen the seat
belt.
Applicable to Canopy Specifications
Applicable to Cab Specifications