Morooka MST-800VD, Operation & Maintenance Manual

Page: 120 / 134

3-26
7.5 CHECK BEFORE STARTING
[1] CHECK COOLANT LEVEL, ADD WATER
Do not suddenly remove the cap when the radiator water temperature is high. Boiling water will spurt out and
cause burns. Wait for the water temperature to go down before removing the cap. When removing the cap, raise
the lever attached to the cap to fully release the internal pressure, then remove the cap.
NOTICE
If the result of the coolant level check shows that more water must be added than usual, there is probably a water
leak, so search for the cause and repair the problem immediately.
1. Open the engine inspection cover.
2. Raise the lever (1) attached to the radiator cap to release the internal
pressure before removing the radiator cap (2), then remove radiator cap (2).
3. Check the coolant level is close to the bottom of the filler port.
If the coolant level is low, add tap water.
4. After adding water, tighten the radiator cap (2) securely.
5. Close the engine inspection cover.
[2] CHECK FUEL LEVEL, ADD FUEL
When adding fuel, never let the fuel overflow from the tank. This will cause fire.
1. Check the fuel level with level gauge (1)at the side face of the fuel tank.
2. Release the lock on the cap (2) with a key and remove the cap (2) from the
fuel tank and add fuel through the fuel filler.
3. Check the breather hole on the inside of the cap, and if it is clogged, wash it.
4. After adding fuel, tighten the cap (2) securely and lock up it with a key.
Always fill the fuel tank after completing t
he day’s operation.