8
Morningstar Corporation
2.2 Wall Mounting
Step 1
Locate a suitable mounting surface that is protected from direct sun, high
temperatures, corrosive fumes, and water. Do not install in a confi ned
area where battery gasses can accumulate.
Step 2
Place the Meter Hub on the surface where it will be mounted and
determine where the cables will enter/exit. Be sure there is suffi cient
bending room for the communication cables. Verify that the mounting
screws will not penetrate wires or other objects located on the opposite
side of the surface.
Step 3
Hold the Meter Hub in place and use a pencil or pen to mark the surface
at the location of each of the four mounting holes. Remove the Meter
Hub and drill 3 mm (1/8”) pilot holes at each mark.
Step 4
Place the Meter Hub onto the surface and align the mounting feet
holes with the four pilot holes. Use #10 screws (included) to secure the
Meter Hub to the surface.