Page 41
SYSTEM
Trouble Shooting
Paper crease out of square
Paper jamming
Check that the sheets are all square and exactly the same size before loading the
stack on to the table.
Check that the adjustable side lay has been correctly positioned ie. No further than
0.5mm (0.020”) from the paper stack.
Check that the blade tilt mechanism is correctly set.
Check that the leading edge of the paper is not being damaged by the paper gate.
If this is occurring, check that the suction slot and the paper gate have been
correctly set.
Check that the first crease / fold position is not too close to the leading edge of
the paper. A minimum distance of 50mm (1.96”) is recommended.
Crease Position Inaccuracy
Paper fold out of square
Check that the crease profile has not been set too deep.
Check that the correct Blade Set is fitted. (Standard Blade Set for material
thickness of 0.25mm (0.010”) and above, Narrow Blade Set for material thickness of
0.25mm (0.010”) and below).
Note:- the best fold squareness is achieved when the fold is not on the center of the
crease, but to one side or the other.
Check that the fold is to one side of the crease center line.
Check that the roller gaps are not too tight and squashing the crease.
Check that the roller gaps are not too large and allowing the paper to slide
(especially so on glossy paper).
If jamming is occurring in the Perforator - adjust the Hubs (see Pages 15 & 38).
Digifold 5000P
