Page 13
SYSTEM
Roller Gap 3
Roller Gap 1
INFEED
FIG 13.1
Roller Gap 2
Gap_3
Gap_2
Gap_1
Home
More
Gap Settings
0.6
0.2
0.2
Tilt -0.50
Gap Settings
Setting the Roller Gaps (Gap 1, Gap 2 & Gap 3)
PROCEDURE.
The roller gaps can be adjusted to suit the thickness of the material being creased or
folded; and the type of fold being produced. The roller gaps may also require adjustment
if cracking of the print is noticeable. (see Fig 13.1 below).
The roller gaps can be adjusted as follows:-
With the machine switched
(see page 18), move the Selection Switch to the right to
select
.
The gap settings (Gap_1, Gap_2 & Gap_3) can then be adjusted by rotating the Roller
Gap Set Knobs (see FIG 10.1 on page 10).
When setting roller gaps, you
first adjust the gap to a value greater than that required
and then decrease the value to the required setting. (Do not set the gap, from a value lower
than that required).
(i) Measure the thickness of the sheet using a Digital Vernier Calliper.
(ii) Set roller GAP 1 to the vernier reading.
(iii) Set roller GAP 2 and roller GAP 3, (for the type of fold being produced), using the
GAP SET GUIDE table on the next page.
ON
Setup
IMPORTANT.
must
Digifold 5000P
Operating the Digifold
