Paper fold out of square
Machine will not start
Paper not feeding
Cracking of the Printed Material along the Crease.
Note:- the best fold squareness is achieved when the fold is not on the center of the
crease, but to one side or the other.
Check that the fold is to one side of the crease center line.
Check that the roller gaps are not too tight and squashing the crease.
Check that the roller gaps are not too large and allowing the paper to slide
(especially so on glossy paper).
Check the power supply to the machine.
Check that the emergency stop button has been released.
Check that the top cover is down.
Check that the delivery unit is in the up position, and located correctly, (the machine
will not start if the delivery unit is not in its up position).
For heavy stocks, very small or very large sheets, embossed or even irregular stock,
it may be necessary to feed the sheets manually - see page 25.
Cracking of the material along the crease may be caused by the following:-
Check that the first crease / fold position is not too close to the leading edge of
the paper. A minimum distance of 50mm (1.96”) is recommended.
Paper jamming
When using dry ink or toner based print engines, the material
be fully
acclimatised for at least 48 hours before putting an image onto the paper.
must
Page 31
SYSTEM
AutoFold Pro
Trouble Shooting
