14
15
TROUBLESHOOTING
ENVIRONMENT PROTECTION
CAUTION! Before troubleshooting, disconnect the appliance from the power supply.
Only a qualified electrician or similarly competent person should perform the
troubleshooting not listed in this manual.
Note: Sounds during normal use are from the compressor and refrigerant circulation.
PROBLEM
POSSIBLE CAUSES
SOLUTION
Appliance not
• Power plug not connected to the • Connect power plug into power
working
power supply or is loose. supply. Ensure connection is
secure.
• Fuse is blown or damaged. • Inspect fuse & replace if
necessary.
• Power supply socket is damaged • Repair power supply socket by
qualified persons.
Appliance
• Temperature set too cold or • Select a warmer setting over-
freeze
temperature setting set to MAX. temporarily.
Food not frozen
• Temperature not adjusted • Refer to “temperature setting”
enough
correctly.
section of this manual.
• Appliance left ajar too long. • Only open the door when
necessary.
• Large quantity of warm food • Select a colder temperature
stored inside in the last 24 hours. temporarily.
• Appliance placed near a heat • Refer to the “location” section
source.
of this manual.
Heavy build-up of
• Door seal is not air-tight • Use a hairdryer on cool setting
frost on door seal
to carefully warm the leaky
sections of the door seal &
shape the warmed door seal
by hand so that it seals
completely.
Unusual noises
• Appliance not placed on levelled • Readjust the feet.
surface.
• Appliance touching the wall or • Move the appliance slightly.
other objects.
• A component (or a pipe) is • If necessary, carefully bend the
touching another part of the component out of the way.
appliance or the wall.
Repairs carried out by inexperienced persons may cause injury or serious
malfunction. Contact a qualitative technician.
Contact the service center if any of the malfunction occur again.
This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance should not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases and the
appliance shall be disposed according to the appliance regulations to obtain from your local
authorities. Avoid damaging the cooling unit, especially the heat exchanger.
The materials used on this appliance marked by the symbol are recyclable.
The symbol on the product or on its packaging indicates that this product may not be treated
as household waste. Instead, it should be taken to the appropriate collection point for the
recycling of electrical and electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of this
product. For more detailed information about recycling of this product, please contact your
local council, your household waste disposal service or the shop where you purchased the
product.
PACKAGING MATERIALS
The materials with the symbol are recyclable.
Dispose the packaging in a suitable collection container to recycle it. Disposal of the
appliance
1.Disconnect the power plug from the power supply socket.
2.Cut off the power cord and discard it.
WARNING! During using, service and disposal the appliance, please pay attention to
symbol similar as left side, which is located on the rear of appliance (rear panel or
compressor) and with yellow or orange color.
Its risk of fire warning symbol. There are flammable materials in refrigerant pipes
and compressor.
Please be far away from fire source during using, service and disposal.
