*REFER TO CHECK SHEET FIRST
1/99
SAFETY OPERATION
INSPECTING CHIPPER KNIVES
CAUTION
BEFORE INSPECTING KNIVES
Always remove ignition key and
install drum lock wedge.
1 .
Remove bolts from hood and open
hood.
2 .
Turn drum by hand until knife is acces-
sible.
NOTE:
Whenever working on the chipper
drum, always insert the drum lock pin through
the access hole in the drum fan. This pin will
hold the drum in place while performing any
knife maintenance. This does not mean the
ignition key can be left in the "on" position.
The drum lock pin is only a secondary safety
system.
3 .
Install drum lock pin.
4 .
Inspect knives. If knives need to be
replaced, refer to "Changing Chipper
Knives" section.
5 .
If knives are in good condition, check
3/4"-16 knife bolts for tightness.
(Refer to torque chart on pg. 22)
6 .
When checking knives, always check
the chipper bearings and grease them.
Also check knife holder bolts.
7 .
After inspecting all knives and bolts,
remove the drum lock pin.
8 .
Close chipper hood, and bolt down
tight.
MAKE ONE LAST VISUAL INSPECTION
1. Check tightness of all bolts.
2. Clear infeed of all debris.
3. You are now ready to begin chip-
ping.
NOTE:
Do not leave the machine unattended with
the engine running.
It is recommended that at least two people
remain at the job site during machine opera-
tions.
Always have an operable fire extinguisher
and first aid kit handy at all times.
Remove the ignition key before attempting
any maintenance.
Check all knife bolts for proper torque.
Drum Lock pin properly installed.
1 5
Summary of Contents for TORNADO 13
