Mora OP 530 Series, Manual, Page: 27 / 28

EN 27
MAINTENANCE
ATTENTION! Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and re-
moving the connector fuse.
Or if the appliance has been connected through a
plug and socket, then the plug must be removed
from the socket.
CLEANING
The cooker hood should be cleaned regularly
(at least with the same frequency with which you
carry out maintenance of the fat filters) internally
and externally. Clean using the cloth dampened
with neutral liquid detergent. Do not use abrasive
products
. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and re-
placement of the filters may cause fire risks. There-
fore, we recommend observing these instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked
to inappropriate maintenance or failure to observe
the above safety recommendations.
GREASE FILTER
Traps cooking grease particles. The grease filter
must be cleaned once a month using non aggres-
sive detergents, either by hand or in the dishwash-
er, which must be set to a low temperature and
a short cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this does
not affect its filtering capacity. To remove the
grease filter, press it and pull it down.
CHARCOAL FILTER
(filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after
more or less prolonged use, depending on the
type of cooking and the regularity of cleaning
of the grease filter. In any case it is necessary to
replace the cartridge at least every four months.
The charcoal filter may NOT be washed or regen-
erated.
REPLACING LAMPS
Disconnect the hood from the electricity.
Warning!
Prior to touching the light bulbs ensure
they are cooled down.
1. Using a flat head screwdriver, carefully loose
the light cover.
2. Remove the damaged light and replace with a
new 230 Volt, 4 Watt (Maximum) halogen light.
Follow package directions and do not touch
new light with bare hands.
3. Reinstall the light cover.
If the lights do not work, make sure that the lamps
are fitted properly into their housings before you
call for technical assistance.