13
3.
Position the upper Bpillar trim (1) into place and seat
the clips (2) fully.
4.
Position the seat belt turning loop (2) onto the height
adjuster (1) on the upper sport bar. Be certain that
the seat belt webbing between the retractor and the
turning loop is not twisted.
5.
Install and tighten the screw (3) that secures the turn
ing loop to the height adjuster. Tighten the screw to
40 N∙m (30 ft. lbs.).
6.
Engage the upper edge of a new trim cover (4) over
the top of the turning loop. Then squeeze the lower
end of the trim cover and the turning loop together
firmly and evenly until the engagement tabs of the trim
cover snap into the slots of the turning loop.
7.
Position the seat belt (3) lower anchor to the mounting
hole on the outboard side of the front seat (1) cushion
frame. Be certain that the seat belt webbing between
the turning loop and the lower anchor is not twisted.
8.
Install and tighten the screw (2) that secures the lower
anchor to the seat. Tighten the screw to 40 N∙m (30
ft. lbs.).
Dec 31, 2010
K6861157 Rev. 1
