9
4.
Install SKREEM Interface Module.
A. Following the directions on the
supplied ampule of adhesive
primer, apply a thin coating of
primer to the entire SKREEM
transceiver antenna coil. Allow the
primer to dry for 5 minutes before
proceeding to the next step.
Note:
Use goggles and gloves to
protect yourself from any acci-
dental contact.
B. Remove backing from one side of
the supplied two-way tape and
apply tape around the transceiver
antenna coil.
C. Route the antenna loop from the
SKREEM Interface module to the
ignition cylinder.
D. Remove the remaining backing on
the tape and position the antenna
loop on the tape around the
transeiver antenna coil. Ensure the
red stripe faces out towards the
key. Press down on antenna coil
to ensure a strong bond.
E. Using a supplied tie wrap, secure
the antenna coil as shown.
K. Connect the 24-way and 10-way
connectors into the PC-12 Remote
Start module. Also, connect the 2-
way antenna connector (on end
opposite the main harness connec-
tions).
24-Way
10-Way
Antenna