8
G. Using the supplied butt connector,
connect the Black/White wire to
the remaining wire from the hood
safety switch.
H. Route the Dk Blue/Yellow wire to
the top of the engine at the coil
connection point as shown. Cen-
ter-splice the Dk Blue/Yellow wire
to the Dk Blue/Yellow wire at the
coil, following the center-splice
procedure on page 7. Solder the
connection
I. Route the Green and Yellow wires to
the relay junction box on the driver
side of the engine compartment.
Remove the horn relay as shown in
the diagram. Slide the supplied Green
wire relay terminal connector over
terminal 85 (pin #1) of the relay as
shown in the diagram.
Remove the parking light relay as
shown in the diagram. Slide the
Yellow wire relay terminal connector
over terminal 85 (pin #1)of the parking
light relay as shown in the diagram.
Re-insert the relays into place.
Route the wiring from the relay
connectors out of the junction box
and connect the Green wire of the
jumper to the Green wire of the
harness using the supplied butt
connector. Connect the Yellow wire
of the jumper to the Yellow wire of the
harness using the supplied butt
connector.
F. Route the four remaining wires
(Black/White, Green, Yellow, and
Dk Blue/Yellow) through the cowl
panel and into the engine compart-
ment.
123456
123456
PIN #1
Horn & Parking Light Jumper (included)
1234567
1234567
1234567
HORN
12345678
12345678
12345678
PK LTS