Audio System Upgrade Package
2011-UP Jeep Wrangler 2-Door
10” Subwoofer Kit
Installation Instructions
77KCK051
6-3-2011
Page 3 of 6
© 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Wire Harness Installation
8. Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove
it. Fig. 6
9. Using a razor knife make a small cut in the center of the grommet. Pass the end of the wire with
the small terminal on the end through the grommet and pull the grommet up to the point where the
plastic sheathing starts. Fig. 7
10. Run the wire through the grommet hole in the fire wall and reinstall the grommet.
11. Run the wire along the top of the fire wall toward the battery and secure with wire ties.
12. Remove the top of the fuse cover and using a 13mm socket and ratchet loosen and remove the nut
on the positive battery accessory lug. Fig. 8
13. Connect the ring terminal of the power harness to the lug and retighten the nut.
14. Using a panel removal tool remove the four plastic retainers (three in front door opening and one in
rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 9
15. Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
