Audio System Upgrade Package
2011-UP Jeep Wrangler 2-Door
10” Subwoofer Kit
Installation Instructions
77KCK051
6-3-2011
Page 5 of 6
© 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Fig. 11
24. Install the supplied two pin connector by inserting the terminal on the end of the power wire into
the back of the connector until it clicks and locks. Fig. 11
25. Depress the blue terminal retainer down in the center of the connector.
26. Using a 10mm socket and ratchet remove the bolt securing the support brace and connect the
ground wire as shown in Fig. 12.
27. Run the wire harness along the floor under the rear seats to approximately the middle of the
vehicle and pull the end of the harness under the seat to the cargo area. Fig. 13
28. Set the subwoofer in place and connect the wire harness.
29. Align the mounting bracket with the anchor points at the bottom of the seat and press the enclosure
down until it locks into place. Fig. 13
30. To remove the subwoofer press the tabs on each side of the mounting bracket while lifting up.
Disconnect wiring. Fig. 14
Fig. 13
Fig. 14
Fig. 12
