The Interface Solution Experts
11
THZ
2
&
TDZ
2
Programmable Smart HART
Temperature Transmitter and Display
Configuring the THZ
2
and
TDZ
2
One of the benefits of these transmitters is that there
are no internal or external controls to adjust or settings
to change. All operating parameters are set using
either a HART Communicator or a PC and Moore
Industries’ Intelligent PC Configuration software.
The software settings are downloaded to the
transmitter in the form of a Configuration File and
stored in the instrument’s memory. You can save
a backup copy of the file on your PC hard drive or
external media. The transmitter communicates with
the PC through an RS-232 port or USB port. A HART
modem connection to the PC’s serial port may also be
used.
You can configure the THZ
2
or TDZ
2
with either a
standard HART Communicator or our PC software.
Figures 7 and 8 (depending upon your instrument’s
housing) and Table 5 provide the information you need
to configure your unit.
Using a PC
If you are going to use a PC to configure your unit,
first install the software as described on the next page,
then setup the hardware as shown in Figures 7 or 8
(depending upon your instrument’s housing).
Installing the Configuration Software
Refer to Table 5 for the equipment needed.
1. Insert the
Moore Industries Interface Solution
PC Configuration Software
CD into the CD
drive of the PC. Access the CD and open
the
THZ2_TDZ2
PC Configuration Software
folder.
2. Double-click the installation program located
in the folder. Follow the prompts to correctly
install the program.
Once the Configuration Program is installed on the
PC, the THZ
2
or TDZ
2
can be connected to equipment
to simulate input and monitor output. You can then
change the transmitter’s operating parameters.
