Page 36
Voyager OS User’s Manual - Appendices
Page 37
Voyager OS User’s Manual - Appendices
VX-351 CV Output Expander - Description
The following is a description of the outputs and functions contained in the VX-351 CV Output Expander.
TOUCH
This group of four outputs is not used with the Voyager OS.
KBD
This group of outputs is generated from the Voyager’s Keyboard. There are three control voltages (Pitch,
Velocity and Pressure) and one gate signal.
PITCH: This is the CV determined by the note that is played on the Keyboard. It is the same voltage
used for determining the pitch of the Voyager’s Voltage Controlled Oscillators.
VEL: This is the CV determined by the velocity used to press a key.
PRESS: This is the CV determined by how much pressure is exerted on a key after it is pressed.
GATE: This is the gate signal generated when a key is pressed.
WHEELS
This group of outputs is generated from the Voyager keyboard’s Left Hand Controller Wheels.
PITCH: This is the CV generated from the Pitch Wheel.
MOD: This is the CV generated from the Mod Wheel.
PEDALS
This group of outputs is generated from the MOD1 and MOD2 jacks on the rear panel of the Voyager.
MOD1: This is the CV generated from the MOD1 input. The MOD1 Input is a CV input on the Voyager
that determines how much of the PEDAL/ON Mod Bus Source goes to the PEDAL/ON Mod
Bus Destination. With nothing plugged into the MOD1 jack, the voltage that’s present at the
MOD1 jack is +5V. When a CV is plugged in to the MOD1 input, that voltage replaces the +5
Volt signal at the MOD1Input. The Voltage that appears at the MOD1 Input is duplicated at the
MOD1 output.
MOD2: This is the CV generated from the MOD2 input. The MOD2 Input is a CV input on the
Voyager that is an external modulation source for the Mod Busses. With nothing plugged into
the MOD2 jack, the voltage that’s present at the MOD2 jack is +5V. When a CV is plugged
in to the MOD2 input, that voltage replaces the +5 Volt signal at the MOD2 Input. The Voltage
that appears at the MOD2 Input is duplicated at the MOD2 output.
LFO
This group of outputs is generated from the Voyager’s LFO. There are two CV waveforms available here
(triangle and square) and both can be used at the same time
TRIANGLE: This is the triangle wave output of the LFO.
SQUARE: This is the square wave output of the LFO.
