Page 28
Voyager OS User’s Manual - The Components
Page 29
Voyager OS User’s Manual - The Components
LFO/Sample and Hold Section Controls
Rate:
The
RATE
control sets the frequency of the LFO. The
RATE
control frequency range is approximately 0.2
to 50 Hz.
Wave:
The
WAVE
control selects the LFO waveform. There are four waveforms available:
-
Triangle
-
Square
-
Stepped Sample & Hold
-
Smooth Sample & Hold
Additional CV Connections
:
LFO Rate:
The
LFO RATE
jack accepts an expression pedal or a control voltage from -5 to +5V. A positive voltage
applied here adds to the position of the LFO
RATE
control, while a negative voltage will subtract from the
position of the LFO
RATE
control.
NOTE:
The S&H GATE jack will only work with a +5V Gate input, not a footswitch.
LFO Sync:
The
LFO SYNC
jack accepts a footswitch or a +5V Gate input. Closing the footswitch or applying a gate
signal here will retrigger the LFO waveform.
S&H In (Sample and Hold Input):
The
S&H IN
jack accepts an expression pedal or a control voltage from -5 to +5V. The voltage on this jack
is the signal source for the Sample and Hold circuit input.
S&H Gate (Sample and Hold Gate):
The
S&H GATE
jack accepts a +5V Gate input. Applying a gate signal here will trigger the Sample and Hold
circuit.
PERFORMANCE TIP:
By applying an external voltage to the LFO RATE jack you can
control the LFO frequency well beyond the specifi ed range. Rates lower than one cycle
per minute are possible, as are frequencies that go well into the audio range.
