Page 40
LP User’s Manual - The User Interface
Page 41
LP User’s Manual - The User Interface
CALIBRATION (con’t)
PITCH WHEEL AMOUNT:
This option allows you to select Pitch Wheel Amount calibration. This
calibrates the Pitch Wheel Amount parameter to precise semitone val-
ues (+/- 2, 3, 4, 5, 7 and 12). Press
ENTER
to access the Pitch Wheel
Amount calibration menu.
You will be asked if you wish to proceed. Use the
VALUE
knob to
select YES or NO, then press
ENTER
. If you are uncertain, or if you
change your mind about performing this calibration, select NO and
press
ENTER
. You will be returned to the System Utilities Calibration
menu. Otherwise, select YES and press
ENTER
.
Calibration will begin, and the display will appear as shown. The fi rst
number displayed is the amount of pitch bend being calibrated (in this
example, +2 means ‘plus two semitones’). The second number is the
calibration value (this is the value stored in the LP’s EEPROM), and the
third number is the actual measured note, which is displayed in MIDI
Note Number Cents (in this example, ‘62.36’ indicates MIDI note 62,
and the actual measured note is 36 cents sharp). All Pitch Amount
calibrations are based on MIDI note 60, so for a calibration value of +2,
the target note value is 62.00. As the calibration operation proceeds,
the calibration values will increment fi rst through all of the positive
Pitch Wheel amounts (+2, +3, +4. +5, +7, +12) and then all of the
negative Pitch Wheel amounts (-2, -3, -4, -5, -7, -12).
When the calibration is complete, the message ‘SUCCESSFUL’ will ap-
pear on the display and the new calibration values will be stored in the
LP’s EEPROM. To exit the calibration, press
ENTER
to return to the
System Utilities Calibration menu or press
MASTER
to exit the calibra-
tion and return to the highest level of the System Utilities menu.
