NOTE: This hi-res color camera uses a 1/4" chip and a 3-6mm auto iris lens. It is
comparable to a 1/3" chip using a 4-9mm auto iris lens.
The operational settings are defined by four dip switches located on the side of the PC
Board (Figure 12 and 13). Moving the switches to the UP position will activate specific
settings. Refer to the chart below.
Figure 12
Auto Iris
Adjustment
Screw
Dip Switches
Figure 13
Dip Switch UP DOWN
1
(Iris) Auto Iris On Position for Fixed Lens
2
(Flickerless) Shutter speed Normal
fixed at 1/100 sec.
3 (Back Light ON Normal
Compensation
4
(Synch Mode) Internal Synch Line Lock Mode
HIGH-RES COLOR & DAY/NIGHT w/AUTO-IRIS
HIGH-RES COLOR, FIXED LENS
FIXED AND FIXED VARI-FOCAL LENSES. There are no user adjustable settings on these
units (Figure 14)
AUTO IRIS LENSES: The auto iris can be adjusted if needed. See the Troubleshooting
section for instructions.
Figure 14
Auto Iris
adjustment
screw
COMPLETION OF INSTALLATION
1. When the desired focus is achieved for each camera, adjust the segmented bracket
arms to the desired viewing angle. Once you've finished, put the dome back in place
and check to be sure none of the cameras touch the dome. If one or more do, readjust
the arm(s) until they are clear of the dome.
2. Reattach the dome by putting it in place, turning clockwise until it locks, and then
tightening the locking screws.
NVT INSTRUCTIONS
The cameras included in the Q-View™ series have the option of transmitting video
signals to NVT receivers via unshielded twisted pair cable. You must purchase the
receiver separately. Instructions for connecting the receiver end of the the unshielded
twisted pair cable will be included with the NVT receiver. Following are instructions
for connecting the unshielded twisted pair cables to the RJ45 (Cat. 5) cable running
outside your housing.
UNSHIELDED TWISTED PAIR
VIDEO WIRING
1. Video for all four cameras is contained in the one RJ45 (Cat. 5) cable. An RJ45
female coupling is provided so that all connections can be made with an RJ45 connec-
tor. The following is the wiring diagram for the four twisted pair wires that are included
with the Cat. 5 cable.
2. Connect the other end of the unshielded twisted pair cable to the NVT receiver.
CAUTION:
The unshielded twisted pair video signal is polarity dependent. The positive
video wire for each camera MUST be connected to the positive terminal on the NVT
receiver, and negative MUST be connected to negative.
3. When using unshielded twisted pair cable you DO NOT need the BNC connector. All
four BNC connectors are provided inside the housing for testing purposes. Be sure that
there is no video connection other than the unshielded twisted pair cable.
NOTE:
The customer must purchase the Video Transceiver from
NVT. Part numbers are:
• NV-212A (500 ft.)
* NV-213A or NV-213A-M (1000 ft.)
• NV-652R, NV-862R, or NV-1662R (3000 ft.)
PIN WIRE COLOR CAMERA NUMBER
1 White/Green Camera 1 +
2 Green Camera 1 -
3 White/Orange Camera 2 +
6 Orange Camera 2 -
5 White/Blue Camera 3 +
4 Blue Camera 3 -
7 White/Brown Camera 4 +
8 Brown Camera 4 -
