Figure 4
Twist and
Secure
FOR OPTIONAL PENDANT MOUNT
1. This unit includes a 1 1/2" NPT housing for a standard 1 1/2" NPT pipe. The RH7C
can be used with other brackets designed with 1 1/2" male pipe threads, such as the
Moog Videolarm WM20G and WM20 wall mount brackets.
2. Attach the housing coupling (Figure 3).
NOTE:
Pipe threads should be clean and rust free. Use a sealer (such as Teflon™
tape or silicone sealer) on the threads.
Wiring Color Code for Power
1
Camera Power (24 VAC)
Red
2
Camera Power (24 VAC)
Orange
3
Accessory Power (24 VAC)
Yellow
4
Accessory Power (24 VAC)
Green
POWER
4. Attach the wires from the wall to the connector provided, using the wiring color
code chart as a guide.
5. Once all wiring connections are made, place the wires inside the wall mount
bracket and close the access door. Secure with the screw removed earlier.
6. Clean the outside of the dome.
Figure 2
Access panel
3. Open the access door on the bottom of the wall mount by loosening the screw
nearest the mounting plate (Figure 2).
Figure 3
Add thread sealing
tape
1. Mount the housing assembly to the mounting bracket and housing coupling. A
safety cable is included with the housing to temporarily hold it while making wiring
connections. Loop the safety cable over one of the set screws on the housing coupling
and make the appropriate connections using the (2) screw-down connectors supplied.
2. Undo the safety cable and twist the housing onto the housing coupling. Secure all
(3) setscrews provided on the housing coupling (Figure 4, next column).
3. Clean the outside of the dome.
