- -
Chart A Wiring Color Code
Power and Control Inputs
(Outside of housing)
POWER
1
Camera and Heater/Blower (24 VAC) Yellow
2
Camera and Heater/Blower (24 VAC) Green
ALARMS
1
Alarm 1
Blue
2
Alarm 2
Violet
3
Alarm 3
Gray
4
Common
White
DATA
1
RJ45 Ethernet Connector
RJ45 Ethernet Cable
+12 VDC -12 VDC
Connect power plug to camera per camera instructions.
ALARMS
1
Alarm 1
Blue
2
Alarm 2
Violet
3
Alarm 3
Gray
4
Common
White
Set screws
Plastic Cover
MOUNTING THE HOUSING
1. Mount the housing assembly to the mounting bracket and
housing coupling. A safety cable is included to temporarily
hold it while making wiring connections. Loop the safety
cable over one of the set screws on the coupling and make
the appropriate connections using the (2) screw-down
connectors supplied.
Chart B Power and Control Outputs
(Inside of housing)
CAMERA POWER
Remove the power plug from the power supply provided with
the camera and connect it to the power supply inside the
housing.
GENERAL INSTRUCTIONS
The RH7C/N1 is setup with (2) individual power inputs.
1. Accessory Power (yellow and green wire)
2. Camera Power (red and orange)
If you wish to provide a single power transformer it is
recommended that:
A. Be certain that you know the total power consumption of
housing Heaters (50 watts) + Blowers (2 watts) + camera/
pan-tilt (not
supplied), 80 watts.
B. Check the supplied wiring chart to be sure that you have
the proper gauge wire for the distance that you intend to
run your power wires.
C. Bring power to the 3 and 4 position of the power connector
(yellow and green wire)
2. Undo the safety cable, twist the housing onto the housing
coupling, and secure all (3) setscrews provided on the
coupling.
3. Clean the inside of the dome, with the text-wipe provided.
Reattach the housing dome and secure the (3) captive
screws.
Do not overtighten the screws.
Tighten only to the
point at which the gap between the ring and the housing
top closes.
4. Clean the outside of the dome.
