- -
STANDARD INSTALLATION PROCEDURES
INCLUDES MODEL:
WM20G
1. Choose an appropriate location on an outside wall to
mount the WM20G.
NOTE:
Be sure that the wall is sturdy enought to support the
combined weight of the bracket and housing.
2. Place the base against the wall, mark the location of
the four mounting holes, remove the bracket and drill the
mounting holes. Pull all wiring through the wall at this
time (Figure 1).
3. Run wiring into and through the WM20G bracket. Make
sure you also have enough to run into the housing for
connections.
NOTE:
For applications where the wiring cannot be
pulled through the wall, a starter hole is provided
on the side of the bracket near the base. Use this
to drill a larger hole to pass conduit into and
through the bracket (Figure 2).
Figure 1
Starter
Hole
Figure 2
Figure 3
Figure 4
Figure 5
4. Mount the WM20G to the wall (hardware not included).
(Figure 3)
5. Make all wiring connections to the housing, following
instructions provided with the housing (Figure 4).
6. Screw the housing coupling onto the WM20G 1½" pipe
thread (Figure 5). Make sure all attachments are secure.
NOTE: Use Teflon
™
tape
or silicone to seal
the threads
