5
Use the product only for its designed purpose of use. Manufacturer will not assume any responsibility in
case of damages cause of an unappropriated use. Any modification applied by customer on the original
product will have a negative impact on its safety, cause danger and warranty will be canceled.
General Safety Instructions
WARNING!
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric shock, fire
and/or serious injury. Save all warnings and instructions for future
reference. The product must be installed by a specialist.
Do not use pears that have more power than indicated on the drum
or packaging
Before use, check that the power supply corresponds to that which
is stated on the device’s nameplate. Avoid any unintentional startup.
Do not allow water or other liquids to get into the appliance. Do not
expose it to rain.
Do not use the appliance if the plug, the mains cord or other
components are damaged.
If the mains cord is damaged, you must have it replaced by a
service center authorized or similarly qualified persons in order to
avoid a hazard. Otherwise there is a risk of electric shock. Never try
to repair the appliance yourself.Never plug in or unplug the mains
plug when your hands are wet.Avoid pulling the cord when removing
the plug from the socket. Instead, hold the plug. Make sure that the
mains cable is not squeezed, bent, damaged by sharp edges or put
under mechanical stress. Avoid excessive thermal stress on the
mains cable from extreme heat or cold. Do not modify the mains
cable. Otherwise the mains cable may be damaged. A damaged
mains cable can cause a deadly electric shock.This device is not
intended for use by persons (adults and children) with physical,
sensory or mental impairments or lacking experience and/or
knowledge of use unless they are supervised by a person
responsible for their safety or have received instructions from that
person on how to use the applicator. Children should be supervised
to make sure they do not play with the device.
WARNING!
Do not tighten the screws completely until the product
has been fully assembled. If you do tighten them completely at an
early stage, significant problems could occur during the further
assembly of the product.
