EN
21
PAUSING THE MACHINE
l
Keep the
START/PAUSE
button pressed
for about
2
seconds
(the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
l
Press the
START/PAUSE
button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
programme selector to the
Off
position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
l
This button allows to delay the start of the
programme from
30 minutes
to
24
hours
in
30 minutes
intervals.The
delay
selected is shown on the display.
l
After pressing the
START/PAUSE
button
the time show
n will
decrease minute
after
minute.
l
It's possible
to
transform a cycle
from
automatic to programmed, up
to
3
minutes
after the start of the cycle.
l
When pressing the button this
increases the
time in
10 minute
intervals. After this
selection
,
to reset
the automatic drying
functioning
it
is
necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly 3 times.
l
This button allows to set the desired
dryness level editable option up to
3
minutes
after the starting of the cycle:
Ready to Iron
: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger
: to get garment ready to
be hang.
Dry wardrobe
: for laundry that can be
directly stored.
Extra-dry
: to get completely dry
garments, ideal for full load.
DELAY START button
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME SELECTION button
MEMORY button
This button allows you to store the options
set on a cycle.
MEMORY:
select the programme and the desired
options, then press the button
MEMORY
for
3
seconds
(before starting the cycle). The
writing
MEMO
will blink for
2 seconds
and the options connected to the cycle
selected will be set.
RECALL:
A
fter the selection of the cycle press
the button
MEMORY
to
recall the
stored options (not the cycle).
The delay start function can't be
memorized.
DRYING SELECTION button
Summary of Contents for MIHP75
Page 29: ......
