Page 16
H42DF-O Outdoor Gas Fireplace
Part No. XG0149
Top
Right Log
Top Right
Log
Align Pins
Align Pins
Top
Left Log
Top Left
Log
Notch in Log
Installation
H42DF-O
Installing the Log Set
Installing the Logs:
The
H42DF-O
is supplied with a seven ceramic fibre log logset. Unpack
the logs and handle them very carefully.
Step 1.
Remove the glass door as described on Page 15.
Figure 30a.
Placing Bottom Rear Log.
Step 2.
Place the bottom Rear log as shown in figure 30a.
Pilot Assembly
Fireplace Base
Rear / Bottom Log
Notch in Log
Figure 30b.
Placing Bottom Right / Left Logs.
Step 3.
Place the bottom Right and Left logs as shown in
figure 30b
.
Step 4.
Place the Top Right log as shown in
figure 30c
. using the (4) four
alignment pins protruding from the top of the Right and Left Bottom
Logs, as shown in
figure 30c
. With these pins align the Top Right
and Left logs using the predetermined alignment holes cast into
Figure 30c.
Top Left / Right Log.
the underside of the logs, as shown above,
figure 30c
insets.
Step 5.
Place the Centre Front log ,
Figure 30d
below, as shown using the
notch cast in the Bottom Rear log as shown in
figure 30c
above.
Figure 30d.
Placing Centre Front Log.
Step 7.
Place the Right Centre log as shown in
figure 30e
.
Figure 30e.
Placing Right Center Log.
Step 8.
Place the Right Center log as shown using the notch in the Top
Right log as a guide, figure 30f.
Figure 30f.
Placing Embers.
Step 9.
Place the Embers as shown in
figure 30f
.
Arrange the ember chips on top of the burner tray. Care should be taken
when placing the embers, as blocked burner ports may cause an
incorrect flame pattern, carbon deposits and delayed ignition. Also,
the embers must never be placed in a way that obstructs any of
the air inlet ports, located at the rear of the burner, as shown in
figure 30b
.
Right Front
Log
Groove
in Log
Rest Log
Center Front Log
Centerline of Fireplace
Align
Bottom Left Log
Air Inlets
Align
Bottom Right Log
Fireplace Base
CAUTION:
■
If logs are not placed properly, excessive sooting
will result.
■
The surface of the logs will crack due to the heat from
the flames. This is a normal occurrence.
Place Embers in this area
