Page 9
BF-Series-ST Gas Fireplace
Part No. XG0711 - 022410
f i r e f e a t u r e
Installation
Figure 14.
Step 1. (Door Trim )
Figure 15.
Step 2. (removal of
Trim)
Figure 16.
Step 3 (Removal of
Door Frame)
Figure 17.
(Completed Re-
moval)
Removing and Installing
the Doors
(Both sides typical)
Removing the doors:
The
BF-ST
Door-Window outer trim is held in place by magnets, and
the Door-window frame are held in place by fine-thread 10-24 screws.
Follow the process below to remove, or install the items described.
Figure 14
. The Fireplace as it is received from Montigo.
Figure 15
.
(Step 2)
Remove the Door-window trim by grasping the metal
firmly and pull it free it from the frame.
Note: Hold it as shown in Step 2
to release the hold of the magnets.
Figure 16
.
(Step 3)
Remove the Door-window assembly by turning the
10-24 screws counterclockwise. Note: Have someone hold the door-
window assembly in place until all screws are removed. Then grab the
assembly from either end lifting it away from the fireplace. Place it in a
safe location to store or clean.
Figure 17
.
(Step 4)
Proceed to remove glass on other side if required.
Place the glass in a safe place and proceed with service or cleaning.
installing the doors:
Install the doors in reverse order as shown in Steps 1 through 4.
Important: when re-installing screws into their original location, ALWAYS
hand tighten with screwdriver to ensure proper tension on all screws.
Cautions:
Fireplace gas control must be in the “OFF” position and pilot
and main burners extinguished when cleaning appliance
with a vacuum.
Doors and logs can get very hot. Handle only when cool.
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Do not operate this fireplace without the glass door, or with a
broken glass door.
