For Canadian installation in both flush and down-
rod mode the safety cable must be installed into
the house structure beams using the 3” lag screws
provided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
7
8
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
Canadian mounting only
Safety Cable
Lag Screw
11
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
9
Pass leadwires and safety cable through
the canopy.
Remove side covers from canopy expos-
ing 4 holes. 2 closed holes and 2 open
“L” shape holes.
17
16
Lift Conopy allowing the 2 studs to
protrude through the canopy.
12
Next lift the cover ring and install knurled
nuts as shown. Tighten the knurled nuts
securely. The canopy should adjust for
any irregularity in the ceiling or Outlet
box.
13
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house.
refer to safety Tips section of
manual.
10
Cover Ring
house
Fan
Blue
Black
White
Green
Black
White
Ground
Go to step
25 to finish
installation.
Remove the 2 yoke set screws as shown
above.
Flush Mount Installation
14
Remove the 3 yoke screws with the
keyslot holes and save.
15
safety
cable
3” lag
screw
lock
washer
washer
