Monte Carlo Fan Company 3ALBR60 D Series, Owner'S Manual And Installation Manual

Page: 6 / 9

6
© 2020 Monte Carlo Fan Collections
12/2020
Remote Controller Operation
Remove the battery cover from the remote control transmitter and install
batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries.
Note
: If not using for long periods of time, remove battery to prevent
damage to remote transmitter, and store the remote transmitter away from
excess heat or humidity
Dimming, Non Dimming Setting (Only available for fans with light)
In the dimming mold, it is a light dimming selection and it is to be used with
dimmable luminaries. The remote controller is set with dimming function at
factory.
In ON/OFF (non-dimming mold), it is for light ON/OFF only (non-dimming
function).
The buttons on the remote control transmitter control the fan speed and light as follows.
Fan speed
1 = minimum speed 2 = low speed 3 = medium low speed
4 = medium speed 5 = medium high speed 6 = high speed
This button turns the fan off.
Forward
/
Reverse button- This button is to control direction of fan rotation. Press once
to change direction of the fan rotation. Fan must be running to reverse.
Light button- Press this button to turn light on or off.
Light button- Press this button to desired brightness, dim to bright.
Light button- Press this button to desired brightness, bright to dim.
Breeze-
Press the Breeze button, fan will operates at high speed (6
th
) for 30 seconds, then automatically
change to 5
th
, 4
th
, 3
rd
, 2
nd
, 1
st
at intervals of 30 seconds, and then change it from Low speed (1
st
) to
2
nd
, 3
rd
, 4
th
, 5
th
, 6
th
repeat the cycle until the breeze mold is canceled.
Breeze mold can be erase by pressing the buttons of power or speed control.
Note : This remote controller has auto resume function, the fan and light will maintain the last setting if
turned off with exception of the Breeze mold.
Battery cover
DIM (D)
ON/OFF (O)
SET
SET
1
0
1
0
1
0
Universal Mode and Learning Mode
There are “Universal Mode” and “Learning Mode” (marks “0” and “1”) with the remote controller.
If choosing “
Universal Mode ”, simply place dip (code) switch at LOWER position (mark “0”). Your fan with
the remote controller is ready to use.
Note : If using universal mode, your fan can be controlled with other remote transmitters with the same
setting.
To control the fan with specific remote transmitter, choose “
Learning Mode ” by placing the dip (code)
switch at UPPER (mark “1”) position and then make learn function setting as below.
Learn Function Setting
Restore power to your fan, press and hold the “SET” button to pair the Transmitter and receiver. You must
press the ‘SET” button within 60 seconds of restoring power to the fan.
Note:
Fan will operate at minimum speed and light will blinks after the setting.
Note
: If the power is on already, you must turn the power off then turn the power back for remote control
setting.
Note
: If reset the dip switch to “0” position (universal mold). It has to be paired again, run the learn function
setting.