passive loudspeaker system
W400P
Wiring of the connection cable to the
Speakon
®
connector:
Strip the cable for 20 mm of length and strip each
wire for 8 mm of length . We suggest to use a
cable with 1,5
÷
2mm
2
section wires (the insert
terminals are however suitable for a cable with
wires up to a section of 4mm
2
/12AWG).
Insert the cable into the bushing and into the chuck
(white chuck for a cable diameter of 5
÷
11mm;
black chuck for a cable diameter of 9.50
÷
15mm).
Fit a ferrule at the end of each wire and connect
wires on the insert.
The wire ends can be clamped in the terminals using
an Allen wrench (1,5 mm) or soldered by always
paying attention to the symbols shown on the
connector body: connect the positive wire to the
terminal labelled 1+, the negative wire to the
terminal labelled 1- . Terminals 2+ and 2- are not
used.
After connecting the wires to the insert, lead it
through the body and screw down the body with
the bushing.
Mating connector is a Neutrik Speakon
®
model NL4-FC.
If not available, model NL2-FC may be used:
this version has contacts 1+ and 1- only.
Speakon
®
connector
SPEAKON
®
CONNECTOR
HOUSING
BUSHING
CHUCK
CABLE
FERRULES
FOR
STRANDS
INSIDE
VIEW
INSERT
WIRES
CABLE
WIRES
20 mm
8 mm
SETSCREWS
11
ENGLISH
