Montarbo TANK201P, Instruction Manual

Page: 4 / 16

8
ENGLISH
The trademark Neutrik Speakon
®
is property of Neutrik
LINK
min 8 Ohm 8 Ohm
IN
Tank241P / Tank201P - Description
Tank241P / Tank201P - Connections panel
A Tank241P - Tank201P : 1” shielded compression driver with
1.4”
voice coil, loaded by a 80° x 60° horn.
B
Tank241P : two 12" , custom built, woofers with super-vented
neodymium magnets (in order to minimize the power compression
effect) and long excursion
2.5" voice-coils, in a symmetrical
(D'Appolito) configuration.
Tank201P : two 10" , custom built, woofers with super-vented
neodymium magnets (in order to minimize the power compression
effect) and long excursion 2.5" voice-coils, in a symmetrical
(D'Appolito) configuration.
D
D
E
F F
A
B G
H
C
BOTTOM VIEW
C
The cabinets, characterized by an essential and rigorous style,
are built from 15mm birch multiply and finished with a special
anti-abrasion paint.
D Steel protection grille.
E
Tuning ports.
F
Transport handles.
G Connection panel.
H Speaker stand adaptor.
Construction and components conform to the highest professional
standards for maximum reliability.
2
1
Connections are the same for both models.
1
- Input connector (Speakon®).
Connect it to the power amplifier or to the powered mixer output.
See connection examples on pages 25, 26, 27 and 28.
2 - Input LINK connector (Speakon®). It is wired in parallel to the in-
put connector and it makes possible to send the input signal to other
equipment (usually to another speaker system).
Always pay attention to the total impedance.
See connection examples on pages 25, 26, 27 and 28.
LINK
min 8 Ohm 8 Ohm
IN
Never connect two power amplifiers to the same
speaker system: doing this may result in serious damage
to the amplifiers.