P6AM
| Owner’s manual
7
P6AM
DSP/FX-AUX
This control is used to adjust the level of respective channel signal sent to the Aux Bus. The configuration is post-
fader so the signal sent to AUX Bus will be affected by the LEVEL control of that particular channel. In this typical
compact unit, the channel signal is not only assigned to external effect or processor equipment directly but also to
internal digital multieffect.
CHANNEL EQ
Each Input channel has its own 2-band equalizer with an adjustable range of +/-15 dB.
The HIGH control creates a shelving filter that will boost/cut all the frequencies above 12 kHz.
You can use it to eliminate high frequency noise and hiss (such as those produced by Tape Recorders) or to boost and
make crispier the cymbals or certain harmonics of the human voice.
The LOW control will create a shelving filter that will boost/cut frequencies below 80 Hz.
Use the LOW control to put in evidence Kick Drum or enhance male voice.
THREE BANDS MASTER EQ
This equalization circuit is inserted before the MAIN level control. You have available 3 controls: BASS, MIDDLE and
HIGH.
HIGH
Use it as a further boost to the overall MIX to get more colour from your program or turn the control down if you want
to avoid high frequency noise.
MIDDLE
This is a unique control designed for a wide variation of middle frequencies.
Turn the control down (from center position) and you will make the human voice more warm and smooth while turning
the control up will enhance vocal intelligibility. Be careful not to boost these frequencies too much to avoid feed back
on microphone inputs.
BASS
Turn the control down (from center position) if you experience rumble or low frequency noise or turn it up to make the
P6AM sound much bigger than what it is.
MONITOR OUT
Connect a powered Monitor to this socket or an external AmMonitor Speaker. You can also use it to connect a
pair of Headphones.
MAIN POWER OUT
You can connect a pair of passive speakers to these Output sockets. The 70 Watt (@ 4 ohms,min) internal amplifier
signal will be assigned to these sockets.
Note
: in case to connect two passive speaker cabinets, it must be sure that load of each speaker cabinet is at least
8 ohms.
MAIN
There is the Main Mix Control adjusting the overall volume assigned to the 2 internalspeakers or to the MAIN POWER
OUT speakers.
MAIN LED METER
This 4 segments LED Meter will monitor the volume assigned by MAIN level control. If the +10 LED flashes, you have
reached limit of the internal 70+70W amplifier and the outgoing signal is approaching distortion. +10 LED should
flash only occasionally. If no LED is blinking, it means that the output level is too low, so either you do not hear any
music or the signal is too low to the noise level. For optimal functioning LEDs marked -10 and 0 should always be
blinking.
6
7
8
9
10
11
12
13
14
