8
BATTERY CAPACITY DETECTION
Use the "Battery Get" command to report the percentage of battery
capacity remaining. It will detect the battery capacity automatically. The
Low Battery Auto Report level is set to 2.4 ±0.1 volts.
RESET TO FACTORY DEFAULT
Open the rear cover to trigger the rear cover switch to send the Alarm
Report. Trigger the reed switch 10 times in 10 seconds. The sensor will
send the "Device Reset Locally Notification" command and will reset to
its factory default settings. Note that this should only be done if the
controller is inoperable or otherwise unavailable.
OVER THE AIR FIRMWARE UPDATES
This sensor supports Over the Air (OTA) Firmware Updates. Refer to your
controller's manual for OTA update instructions. Once the OTA update is
complete, you should reset the sensor to its factory default settings and
perform the inclusion process again.
Note that the OTA update process consumes considerable battery
power. We recommend replacing the sensor's battery with a new
battery prior to performing the OTA update.