Attaching the Strap to the Board Mount
The included nylon straps provide an alternate mounting solution. To attach the straps
to the Board Mount and prepare the assembly for attaching to a board, perform the
following steps:
1.
Choose the strap length that will best fit your board.
2.
Remove the two strap clips from the strap.
3.
One each side of the Board Mount are three slots. Thread one end of the
strap up through the slot closest to the center, as
shown in the image to the right.
4.
Look closely at the strap clip. Note that the clip
lock will only fully engage in one direction and that
the clip base is knurled on the other side. Thread
the strap down through the knurled side of the
strap clip from the top, as shown in the image to the right.
5.
Thread the strap down through the middle slot
as shown in the image to the right.
6.
Thread the strap up through the outer slot as
shown in the image to the right.
7.
Pull the strap to remove any slack.
8.
Repeat steps 3-7 on the other side of the Board
Mount.
The Board Mount assembly is now ready to attach to a board.
Attaching to a Board
1.
Decide where you want to mount the camera on your board. Mark the
position on your board.
2.
Remove the protective film from a Single Sided Adhesive Board Pad and
attach it to your board directly under the mounting location of the Board
Mount.
3.
Remove the protective film from a Single Sided Adhesive Fitting Pad and
attach it to the underside of your board.
4.
Thread one end of the strap up through the one of the slots on the Fitting
Piece then back to up through the locking side of the Strap Clip on the
Board Mount assembly.
5.
Position the Board Mount assembly over the attached Board Pad and the
Fitting Piece over the Fitting Piece Pad on the opposite side. Remove
slack in the strap and lock the clip into place.
6.
Repeat steps 4-5 for the other side of the strap.
7.
The Board Mount assembly should now be somewhat loosely in place.
Pull the straps and mounting pieces to get everything in the perfect
position, then unlock one of the strap clips, pull the strap tight, and lock the
clip into place. Repeat this tightening and adjusting process until the Board
Mount is securely fixed to the board.
Final Adjustments
1.
Once the Board Mount assembly is firmly attached to your board, slide the
camera Mounting Clip into the Mounting Clip Shoe.
2.
Loosen the nut at the base of the mounting arm and the screws on the
mounting arm pivot points. Aim the camera as desired.
3.
Tighten the nut and screws to lock the camera's position and orientation
into place.