24
RS-232 COMMANDS
This section details all available RS-232 commands. These commands can be entered using
RS-232 control software or on the RS232 tab in the Web GUI.
Notes:
•
In the following commands, the [ and ] characters are used to make it easier to read
the command. Do not enter these characters.
•
The period at the end is part of the command and must be included for the
command to work.
•
The commands are case sensitive, so enter them exactly as shown in the tables
below.
Device Control
Command
Description
Feedback Example
PowerON.
Turns the system on.
Power ON!
PowerOFF.
Turns the system off.
Power OFF!
LOCK.
Locks the front panel buttons.
Front Panel Locked!
UNLOCK.
Unlocks the front panel buttons. Front Panel UnLock!
Baudrate[xxx].
Sets the baud rate to [xxx].
xxx= 2400, 4800, 9600, 19200,
38400, 57600, or 115200
Example: Baudrate2400.
Feedback: Set Local RS232
Baudrate Is 2400!
GETGUIIP.
Reports the IP address of the
Web GUI.
GUI_IP:192.168.0.178
SETGUIIP[xxx.xxx.xxx.xxx].
Sets the GUI IP address to
[xxx.xxx.xxx.xxx].
Example:
SETGUIIP:192.168.0.18.
Feedback:
SETGUIIP:192.168.0.18!
STA.
Reports the system status.
. . . . . . . .
