9
•
L R: 5-pin terminal block balanced stereo analog audio output for audio
extracted from the HDMI® output.
6.
CONTROL:
•
TCP/IP: RJ45 Ethernet jack for connecting a computer for control using the built-
in Web GUI.
•
RS232: 3-pin terminal block for connecting a computer using the included RS-232
cable for RS-232 control using the supported RS-232 commands.
•
EDID: 4-pin DIP switch for setting the EDID®.
7.
POWER: DC barrel connector for connecting the included AC power adapter.
Receiver
1.
HDMI Out: HDMI® connector for connecting an HDMI display. The LED on the left
illuminates orange wi
th there is a valid HDBaseT™ link with the matrix. The LED on
the right illuminates green then the video contains HDCP™ content.
2.
IR In: 3.5mm jack for connecting one of the included IR receivers for IR pass-through
control of the video source devices.
3.
IR Out: 3.5mm jack for connecting one of the included IR transmitters for IR pass-
through control of the remote display.
4.
HDBT In: RJ45 Ethernet jack for connecting the Ethernet cable from the matrix.
5.
POWER LED: The LED illuminates red when power is applied.
6.
DC 24V: DC barrel connector for connecting an AC power adapter. Note that the
system supports the Power over Cable (PoC) feature to power the receivers, so only
a single AC power adapter for the matrix is included.
