7
Transmitter Rear Panel
1.
HDMI INPUT: HDMI® port for connecting the HDMI source device.
2.
OUTPUTS: The OUTPUTS section contains an HDMI loop output and four HDBaseT™
RJ45 jacks with PoC support.
3.
IR: A 3.5mm IR IN jack for connecting an IR receiver (not included), a 3.5mm IR LOOP
output jack for cascading to another device, and a 3.5mm IR OUT jack for connecting
an IR transmitter (not included).
4.
ID PRESET: Assigns a single digit ID to the transmitter. When cascading multiple
transmitters and using RS232 control, each transmitter must have a unique ID. Use a
small, flathead screwdriver to set the ID. There are sixteen positions, with 0 at the
fully counterclockwise position and 15 at the fully clockwise position. After setting
the ID, the device must be restarted for the new ID to take effect.
5.
RS232: Two 3-pin RS232 connectors. Connect the included 3-pin to DB9 cable to the
IN connector, then connect the other end to your PC. If cascading multiple units,
use the included 3-pin RS232 cable to connect the LOOP output to the RS232 IN on
the next device in the chain.
6.
EDID: Four DIP switches for setting the Extended Display Identification Data (EDID)
value.
7.
DC 24V: DC barrel connector for connecting the included AC power adapter.
