19
Installation
42" Built-In Refrigerator
PRODUCT
INSTALLATION
The grille panel frame is factory assembled for 84"
installation height. If installation height varies, order
ZG1 trim kit which provides optional side trim pieces.
Cut custom, Lexan
®
or stainless panel to sizes
shown below.
Models
Installation Height
Panel Height Panel Width
42" wide
83-1/2"
8-1/2"
41"
Step 10
Mount 1/4"
top grille
panel
If you are using 3/4" thick custom panels, SKIP THIS
STEP. See page 12 for grille panel sizes. Order the
ZKT kit, and follow the installation instructions
packed with the kit.
The grille panel frame for the top grille is shipped with
the unit.
The refrigerator is shipped with the top case trim
secured at the 83" refrigerator height.
• Loosen 2 screws on both sides and raise the case
trim to meet soffit height, from 83" to 84-1/2".
• Tighten all 4 screws.
To insert decorative grille panel into the frame:
• Remove 2 screws (one each in top corners)
as shown.
• Slide panel into the frame and reassemble.
• Mount panel grille by dropping into the slots on the
case trim.
Screws
1 1/2"
min.
gap
Important:
Maintain 1-1/2"
min. gap between top of doors
and bottom of panel frame.
Step 11
Install
toekick
A custom toekick can be installed to match or
complement the surrounding cabinetry.
A standard toekick is supplied with all refrigerators.
If a custom toekick is to be installed, use the supplied
toekick as a template to cut out notches around hinges
and water line tubing.
For 1/2" to 3/4" thick custom toekicks, additional
material should be removed and cut away. This will
allow the water and electrical umbilical tube to rotate
smoothly when the door is fully opened.
The custom toekick should be installed in such a
manner that it can be removed if service is required.
1/4" Thick Custom Dispenser Model Toekick
1/2" to 3/4" Thick Custom Dispenser Toekick
Remove Additional Material
4-1/16"
Standard Dispenser Model Toekick (Packed with Product)
Standard Non-Dispenser Model Toekick (Packed with product)
3-1/4"
