43
31-49133-1
STEP 4 MOVE LIGHT SWITCH
HOUSING (Cont.)
Ŷ
Align housing key holes over grommets and then
slide back until engaged. Ensure wires do not get
pinched.
Ŷ
Install T20 Torx screw into bottom hole to hold in
place.
Ŷ
Turn on master switch and install front access cover
by replacing 2 T20 torx screws.
Installation Instructions - Reversing the Door Swing
STEP 5 REINSTALL HINGE
BRACKETS
Ŷ
Move top hinge bracket to bottom and bottom bracket
to top.
Ŷ
Ensure the 2 rectangular slots of bracket are on
outside, hinge side of case.
Ŷ
Install both brackets with 3 T-30 Torx screws 45 in/lb
(5.1 Nm).
Ŷ
Start 2 screws in each bracket for hinge mounting but
do not tighten all the way.
Rectangular
Slots
STEP 6 REMOVE HINGES FROM
DOOR
Ŷ
Remove 3 screws securing each hinge from the top
and bottom of the door and one screw securing the
support bracket to the door (T-30 Torx)
Ŷ
Move the hinge assembly to
the opposite end of the door
- top hinge to the bottom and
bottom hinge to the top. Hinge,
L-bracket already attached to
hinge, and support bracket will
all move together.
Ŷ
2 shims between the hinge
bracket and door will be
moved to the other side -
save for installing the hinge.
WARNING
Door Hinge Pinch
Point Hazard
Door hinges are under tension and should be left in
the open position throughout the reversal process.
Closing the hinge can lead to a finger pinch point
hazard.
Hinge
Support
Bracket
Shims
Screws for
Hinge Brackets
Housing Key Holes