42
31-49133-1
Installation Instructions - Reversing the Door Swing
STEP 3 MOVE CONTROL ASSEMBLY
Ŷ
Remove the Phillips head screw from the middle of
the housing on the hinge side.
Ŷ
Insert a flat head screwdriver or putty knife between
the glass front and plastic side and free the control
assembly by prying the plastic pins clear of the side
bracket holes.
Ŷ
Lay the glass assembly on top of the control housing.
Ŷ
Remove 4 screws, 2 on each end, to remove the
housing assembly using a T-20 Torx bit.
Ŷ
Move the housing assembly to the opposite side and
install using the 4 screws, 2 on each side.
NOTE:
Make sure
wires do not get
pinched. On 18”
models, the red/
white/black 5-pin
wire connector
will need to be
removed from the
control board and
routed through
the opposite corner bracket and reconnected to the
control board to prevent pinching the wiring.
Ŷ
Snap glass assembly back onto the control housing
assembly, ensuring plastic pins snap into holes on
the side of the housing.
Ŷ
Reinstall the screw into the housing on the new
hinge side.
STEP 4 MOVE LIGHT SWITCH
HOUSING
Ŷ
Remove front access cover from unit by removing 2
T20 Torx screws (if not already removed)
Ŷ
Turn off master switch
Ŷ
Remove screw with T-20 Torx bit at the bottom
middle of light switch housing.
Ŷ
Slide housing forward and down to remove from case
and grommets on case bottom.
Ŷ
Keeping it connected to the unit, lay housing aside.
Ŷ
Remove 2 grommets with Phillips driver.
Ŷ
Move grommets to the set of 2 holes on opposite
side.
Plastic Pins
(Both sides)
Screw
5-pin wire connector
Wires must be rerouted from one
side to the other for 18” models.
Grommets
Light Switch
Housing
Master
Switch
T20 Torx Screws
Front Access
Cover
