25
Installation Instructions
STEP 18 ADJUST DECORATIVE PANELS-
FLUSH INSTALLATION ONLY
(Cont)
5. Make the final vertical adjustment of the panels. Using
the set screw at the top of the door and drawer, turn
clockwise until the desired gap between the grille
panel bottom and top panel of the door and the
door panel bottom and the top of the freezer drawer
appears satisfactory.
6. Tighten all washer-head screws (NOT SET SCREWS)
firmly to secure brackets and adjustments in place.
Start with bottom edge washer-head screws to
provide support of the door panel. Next, moving on to
top edge to prevent panel from moving from aligned
position. Finish by tightening hinge side washer-head
screws. NOTE: Over-tightening washer-head screws
may result in bending wood panel brackets as well as
misaligning wood door
panels.
7. Drive the door anchor
screws through the
two white plastic
pockets in the side of
each door and into
the door panel (4 each
door) to prevent panel
warping over time.
Turn set screws on top and bottom
of door to move panel up or down
for desired gap with grille panel
bottom.
STEP 19 REPLACE TRIM- FLUSH
INSTALLATION ONLY
1. Replace trim and 4 screws on hinge side of the door.
2. Replace handle visor trim and four screws on the
handle side of the door.
3. Replace trim cover and 4 screws over visor trim on the
handle side of the door.
4. Replace the visor trim and top cover to the top of the
drawer using 4 screws.
5. Replace the side brackets to each side of the drawer
using 1 screw per side.
6. Using 4 screws per side, replace the side trim to each
side of the drawer.
Hinge Side
Door Trim
Top Drawer
Cover
Top
Drawer
Visor
Drawer Side
Trim
Drawer
Side
Brackets
Handle
Cover
Trim
Handle Visor
Trim
Summary of Contents for ZICS360NHLH
Page 27: ...27 Notes ...
