Monogram ZICS360NHLH, Installation Instructions Manual, Page: 17 / 28

STEP 6 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16
”
hex
nut located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the refrigerator.
• For front leveling, use a 1-1/4
”
open-end wrench.
• Adjust height of refrigerator to match installation
cutout opening 83-1/2 to 84-1/2
”
. The refrigerator
should be level and plumb with cabinetry.
NOTE (Flush Installation Only): Raise refrigerator until
the case top comes in contact with the 1/2” spacer
block mounted to the underside of the cabinet soffit.
Refrigerator should be level at fully raised position.
ATTENTION
Les roues de nivellement arrière et les pattes de
nivellement avant permettent un réglage maximal
de 25 mm (1 po). Si l’ouverture pour le réfrigérateur
a une hauteur supérieure à 2,15 m (84-1/2 po),
l’installateur doit élever le réfrigérateur sur une feuille
de contre-plaqué ou des glissières. Il est également
possible d’ajouter des baguettes de finition des
placards sur le haut de l’ouverture afin de la réduire.
Lever le réfrigérateur de plus de 25 mm (1 po)
endommage les pattes de nivellement avant
et les roues de nivellement arrière.
CAUTION
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1
”
. If the
installation requires more than 84-1/2
”
height, the
installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator more
than 1
”
, you will damage the front leveling legs and the
rear leveling wheels.
Installation Instructions
STEP 5 ANIT-TIP PROCEDURE (CONT)
Standard Installation Only (Cont)
• Place your thumb between the plastic straps and bend
up and down to snap the straps off at the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered in place
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
CONNECT POWER CORD:
• Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. Open the grille panel
and reach into the opening at the back to grasp the
power cord. Pull the power cord into the opening as you
push the refrigerator back.
• Gently push refrigerator into the opening with hands
against front corners.
IMPORTANT NOTE FOR STANDARD INSTALLATION: When
the refrigerator is installed under a soffit or if there is
not enough height for this method of security, brackets
cannot be used. Proceed to step 6 to level the refrigerator
and then to step 8 to secure refrigerator to cabinets. See
step 9 if you have metal wall studs. The refrigerator must
be secured to prevent tipping.
Wood Stud
Lag Screw
Anti-Tip Wall Bracket
Anti-Tip Wall Bracket
Bolt
Wall Toggle
Drywall or
Steel Stud