– 18 –
Slide the wire guide out of the bracket,
disconnect the wire harness and the strain
relief, and remove the indicator light harness
(part# WB18T10383 for model ZGU384 or part #
WB18T10384 for model # ZGU385).
5.
Note:
When replacing the indicator light harness,
ensure each insulator is placed directly between
each circuit board and the light harness bracket.
The indicator light harness has a numbered
label at each LED. Each label number matches
the number on the metal housing under the
insulator.
•
•
Remove the 2 Phillips-head screws that attach
each circuit board and insulator to the light
harness bracket.
4.
Wire Harness
Wire Guide
Insulator
Indicator Light Assembly
Each burner utilizes an indicator light consisting of
an insulator and circuit board with an attached Light
Emitting Diode (LED). When a burner knob is turned
on, the circuit board activates the LED and light is
directed to the clear shaft of that burner knob. The
light is reflected up to the indicator on top of the knob.
The circuit boards are wired to an indicator light
harness and are replaced as one unit. This light harness
is enclosed in a housing located under the maintop,
above the burner valves, and can be removed as an
indicator light assembly. It is necessary to remove
the indicator light assembly to access the ignitor and
light switch assembly, burner valves, and manifold.
To remove the indicator light assembly:
Remove the maintop. (See
Maintop
.)
On model ZGU384, remove the top heat barrier
by lifting it out of the burner box.
Remove the two ¼-in. hex-head screws that
attach the indicator light assembly to the
manifold brackets.
Lift the indicator light assembly and disconnect
the wire harness.
1.
2.
3.
4.
Note:
It is
not
necessary to remove the indicator
light assembly from the cooktop to remove the
indicator light harness.
To remove the indicator light harness:
Remove the maintop. (See
Maintop
.)
On model ZGU384, remove the top heat barrier
by lifting it out of the burner box.
1.
2.
Indicator Light Assembly
Wire Harness
Cover
Top Heat Barrier
Remove the two ¼-in. hex-head screws and the
cover from the light harness bracket
3.
Insulator (behind board)