Monogram JP690, Instructions Manual, Page: 6 / 16

Features of Your Electronic Touch Control
Q
When the is first
connected, or when power is
restored after a power failure,
the entire display lights up for 15
seconds. Next, LOCKED appears
for 8 seconds to inform you that the
is locked. Then display
goes blank but remains
locked until you unlock it (see
instructions below).
LOCKED
I
TOUCH TWICE
TO LOCK/UNLOCK
Your has a provision for
locking the control panel to prevent
the cooking units from being
activated
when cleaning
the control panel and to keep children
from operating the
Touch the GE symbol in the center
of the control panel button twice
within 3 seconds and all pads
become inoperative. The word
LOCKED appears in the control
display for 8 seconds and a small
green light directly above the GE
symbol lights up. No cooking
surface can be activated until the
lock is released. If you try to turn
on any cooking surface, the word
LOCKED will appear in each
control display.
To unlock the control panel,
touch the GE symbol twice within
3 seconds.
REAR
ON
—
2 4 6 a
OFF
1
I
1. ON/OFF. Touch this pad for
To raise desired cooking heat,
the desired cooking surface before
press pad with right-pointing arrow
making any additional settings.
(4) until exact heat is reached on
If no heat setting is made within
control display. To lower cooking
15 seconds, the induction coil heat, press pad with left-pointing
automatically shuts off.
arrow until desired heat shows
To turn the induction coil off after
on control display.
touch ON/OFF and remove I
the the cooking surface.
2. Power Control Area. Each
cooking surface has its own power
level pads that let you select LO,
or HI heat.
3. &4. Fine-Tuning Pads. Each
cooking surface has its own pads
that let you fine-tune heat settings
between LO,
and HI. When
you press and hold one of these
pads, cooking heat will change in
one-step increments and color bar
will show exact heat setting.
Remove finger when cooking
heat has been adjusted.
Sometimes grease or water
droplets on the power level pads
will prevent you from changing
the heat level up or down. To
correct this, turn the unit off by
pressing the ON/OFF pad.
Then clean the power level
pads with a cloth dampened
with warm soapy water.
5.
Control Display Bar. Colored
bar lights and shows heat setting in
use. When new setting is touched,
bar changes to indicate new setting.
6