4
Bedienungsanleitung / Instruction
Instruction manual for Monoflo heat mats
Electric connection: 230V / 50Hz
Electric consumption: printed on each heat mat, on average 1.7 Watt per cm²
IPX7
Material: GFK
Sensor of the heat mat, resistance 4.7 k/Ohm at 20°C
Temperature: adjustable with our controller No. 50805, 25°C – 40°C
Temperature of surroundings: 5°C – 40°C max.
Capacity: 80 kg/m²
Installation: only through an electrician
FI- switch: Installation of this switch is mandatory
Manufacturer: Monoflo Produktions GmbH & Co KG
Use: Warming plate for animals
Connection method Z: Electric cable cannot be replaced.
Installation:
The heat mats can only be used in combination with our Monoflo controller No. 50805.
The heat mats must be protected from sharp objects, they may not be bend or drilled. The must
be securely fastened through the existing holes onto a stable and even surface.
Before you hook up the heat mat to the power, the stainless steel cable protection hose must be
screwed onto the ½“ fitting on the heat mat. Please place the washer between hose nut and fitting.
This nut should not be fastened too tightly or it can damage the washer. Afterwards the cable pro-
tection pipe must be fixed against the wall or pen separation and then fastened using hose clamps.
Important is that the animals cannot reach the cable. Once installation is completed, the upper
opening of the cable protection pipe must be permanently sealed against moisture using silicon or
similar sealant.
The electric installation must be done as shown on the plan, which is found inside of the controller.
The hook-up must be done by an electrician.
Attention: When using heat mats without controller you may not install any additional sources of
heat.
When using the heat mats in combination with our controller you may use additional heat sources.
Important though is that the same heat sources are used on the mother plate (the one with the sen-
sor) as on the followings heat mats, which have no sensor.
The heat mats cannot be covered with blankets, straw or any other materials. A heat blockage must
be avoided.
Damaged heat mats or cables cannot be installed. Any repair is to be done by a qualified electri-
cian. These instructions must be translated by our dealers into their respective language.
