FG177 PROVER RevB17 04-04-17
15
1.
Connect the water at the rear (washing machine type hose).
Connect the power to a suitable socket.
2.
Press power switch
(1)
to on position and open the door(s)
3.
Press the water supply control button
(2)
and watch until the water level is
about halfway up the sides of the water tray in the bottom.
Release the button and close the door(s).
4.
Turn the temperature setting button
(4)
to the required temperature,
(usually about 40 degrees).
The heat indicator light
(3)
will come on.
5.
When the light goes out it means the prover is ready for use.
(Usually about 30minutes depending on the ambient temperature etc.)
6.
Check the water level every hour when the prover is in use and top up using
water supply button
(2)
when required.
7.
If auto-switching mode is required then the operator must insure there is
water in the tray before leaving the prover set.
Set the timer to required settings as follows:
OPERATION WITH TIMER FITTED
NOTE
IN ORDER TO MAINTAIN THE HUMIDITY LEVEL WITHIN THE CABINET.THE DOOR
SHOULD BE ONLY OPENED BRIEFLY DURING USE.
