Monitor Audio PLW215 II, Initial Setup Manual

Page: 9 / 134

ENGLISH
monitoraudio.com 7
Platinum PLW215 II
System Format
Sealed cabinet with vibration cancelling driver configuration. 25mm M.D.F construction with internal
bracing and sealed amplifier compartment
Low Frequency Response -3dB @ 23Hz / -10dB @ 18Hz (Free Field) default preset: Music
-3dB @ 19Hz / -10dB @ 16Hz (In Room) default preset: Music
Limited by low frequency protection filter (-3dB @ 12Hz)
Upper Frequency Limit -3dB @ 150Hz
Driver Compliment 2 x 15” C-CAM® sub-woofer driver featuring inverted surround and triple suspension for
increased support at high excursions.
Black single layer, edge wound 3” voice coil with vented pole, vented coil and black CED coated motor
unit to reduce power compression and increase thermal dissipation.
FEA optimised cone, magnetics and suspensions for optimal performance and increased linearity.
Linear Driver Excursion 42mm Peak to Peak. Total displacement 6.4 Litres
Amplifier Power Output Dual amplifier design with a single amplifier powering each driver.
Combined 1400W RMS, 2000W Peak (Burst ratio 1:4 continuous, measured into two nonreactive 4 ohm loads)
Amplifier Classification 2 x Class-D amplifiers; Balanced differential Input; Differentially loaded power supply; DSP controlled.
High current switch mode power supply (SMPSU)
DSP 172MHz DSP Core with 3500 instructions per sample, 139dB of dynamic range and 56-bit double precision
processing, dynamically updated by an 80MHz MCU
Digital Conversion Wolfson Microelectronics (Cirrus Logic) ADC & DAC @ 24bit/48KHz.
(WM8786 ADC & WM8740 DAC)
LED UI Control Panel Adjustable brightness 0% - 100%, configurable auto off feature.
Quick access to menu items: Trim, LPF, Phase, Preset Select.
Room Correction EQ 6 System controlled parametric EQ filters set using advanced detection algorithm. Measurement can be
initiated from the control panel or the SubConnect with up to 6 microphone positions (default 2).
Phase Control 0-360 degrees, Increments of 15 degrees with a pure invert at 180 degrees
Low Pass Filter 2nd or 4th order (12 or 24 dB/Octave), Increments of 5Hz from 35Hz to 135Hz
Auto Sensing Input Level
Requirements Line Level >1mV on unbalanced and balanced inputs.
Auto Standby feature, adjustable between 5-240 minutes in increments of 5mins
Digital Volume Control -11 to +11dB in 1dB increments, Via the control panel.
-80 to +20 in 1dB increments, via SubConnect application
IR Remote Control Supplied with IR remote. Front facing IR receiver with red LED response.
Additional discrete IR codes for automation available in the electronic manual.
All commands are on the Logitech database for use with their all in on remotes.
Audio Input Connection LFE Input with balanced (XLR) and Unbalanced (RCA) inputs,
Stereo Input with unbalanced (RCA) inputs.
Inputs individually assignable to any Preset.
Specifications
cont....